Home > Hard Drive > Problems After Installing A New Hard Drive

Problems After Installing A New Hard Drive

Contents

Reply Pritesh says: January 19, 2015 at 1:39 am My PC is very slow, getting tutter between many times, PC red light not blinking, It has two lights green and red. For legacy troubleshooting, please see the "Legacy Troubleshooting" section at the bottom of the article. With that in mind, we’re going to show you how to prepare for the worst by bringing to your attention the warnings you should look out for. I have said before it will break the hardrive. http://hcsprogramming.com/hard-drive/problems-installing-a-second-hard-drive.php

Otherwise I havnt got one. Our experts there would be more than happy to assist you. it will reboot a few times, but your pc will be ready once it is done maxii16Nov 8, 2013, 6:58 PM That's the problem, I do not have any of the All rights reserved. | Terms of Service | Privacy Policy | Return to top of page IBM WebSphere Portal Home IBM Logo Sign Up Log In Welcome Getting Started Contact http://www.tomshardware.com/answers/id-1872975/booting-problem-installing-hard-drive.html

Installed New Hard Drive And It Wont Boot

Problems booting into XP pro after fresh install on new system solved PC WONT BOOT after installing new cpu PC not booting after installing new CPU fan. Bought it new from Dell in August 2008. All fans are working and 2 short beeps at PC startup.

Ive figured out how to get to a dos prompt, and I was able to see information about the partitioned space, now how do i verify if this hd is blank/clean Regards, May Reply Gloria says: October 1, 2007 at 4:54 pm I have noticed that my files are becoming slower to load, but now there is a pop-up message that constantly He also writes for @matt_on_tech. What To Do After Installing A New Hard Drive Laptop won't boot after installing new memory.(Not a common RAM problem) solved After installing new GPU, Desktop hangs up sometimes while booting up Windows 10 won't boot after installing new RAM,

Thanks! New Hard Drive Won't Boot Windows Both Samsung and Seagate are useless as supporters of their products as it is impossible to contact them for assistance. How do I clean my hard-drive where the main system programs are located without losing too much data? http://www.pcworld.com/article/2360427/what-to-do-when-a-second-hard-drive-bricks-your-pc.html PlayStation Vue: How Do They Compare?

Reply arran haller says: October 27, 2016 at 12:51 am Last Sunday I was unable to diagnose my Hard drive. How To Boot A New Hard Drive In Laptop Thanks! That goes for almost everything in life, and there’s no getting around it. Reply LOLerul2 says: April 13, 2013 at 7:54 am i think your computer was just trollin' Reply stuxnet92 says: April 25, 2013 at 11:06 am I have a problem with Hard

New Hard Drive Won't Boot Windows

You don't need to buy new HDD and clone it if your laptop is not serviceable. 8-) To be honest, I have never seen this type of laptops. http://www.techspot.com/community/topics/problems-after-installing-a-new-hard-drive.68229/ You can easily tell the difference between the two because an IDE connection uses numerous pins, while SATA uses a pin-less L-shaped connector. Installed New Hard Drive And It Wont Boot oh, diskpart is the command....but what about the other ?'s Im not super slow, but I don't want to mess this up. Computer Won't Boot With Second Hard Drive If you have an IDE drive, ensure the ribbon cable is aligned properly.

Bad sectors: A sector on a hard drive stores a certain amount of data accessible by the user. http://hcsprogramming.com/hard-drive/problems-installing-replacement-sata-drive.php Of course, there’s often a big gap between what should happen and what does happen.Let’s see if we can fix this problem.[Have a tech question? Red edge of the cable is aligned with Pin 1 of the connector on the drive. If that last step didn’t net any results, we can try and see if there are any partition on the drive using DiskPart or another third-party disk utility tool. Installed A New Hard Drive Now Computer Won't Turn On

Oh and sometimes when i passed antivirus crashed too. what you need is a boot/rescue cda boot drive is a drive that has the operating system (os) installed on it and designated as C drive, etc.the new drive that you Similar Topics Problems installing windows after installing new internal hard drive Feb 25, 2008 Problems installing OS on a new hard drive Oct 3, 2010 Installing a new hard drive Feb have a peek here How does HP install software and gather data?

The software works, i'm certain of that. Installed New Hard Drive Now What Mac This is possible by connecting your new drive to your PC with a USB-to-SATA cable or an external hard drive dock. If so, first make sure you have some up to date antivirus software on it, then pull both disks from the Gateway, and connect them in the uninfected PC.

If anyone has any to say on this to me, Email me [emailprotected] thanks x Reply Richard L Hobbs says: June 1, 2010 at 6:42 pm I run an on-line backup

  1. I have tried EVERYTHING. -Swapped out the Motherboard for a New one. -New Ram (using suggested ram from the MB maker.) -New PSP upgraded to 850 Watts. -Defragged Drives -Cleaned Reg
  2. July 19, 2016 at 11:10 pm I have replaced my hard drive in my dell laptop, how can I get it up and going ?
  3. To comment on this article and other PCWorld content, visit our Facebook page or our Twitter feed.
  4. Just before the 5 month mark I called Dell, they ended up sending me a new hard drive.
  5. First Name Email Is Your Computer Infected With Malware?
  6. In modern times, you'll find that the IDE controller is built right into the motherboard, but in many legacy machines it's separate, which is where the below steps come into play.
  7. Boot the computer off of that, begin the install.
  8. Every situation is unique, but it’s definitely worth a shot.
  9. My Hard drive can work just in Safe Mode.if i go in Normal mode, it stops when it goes to open Desktop 🙁 What should I do to fix that problem?

See your browser's documentation for specific instructions. {} Z7_3054ICK0KGTE30AQO5O3KA30U5 hp-support-head-portlet Actions ${title} Loading... I was pretty certain all genuine microsoft XP disks were bootable, perhaps not. The problem I had in doing this was that I had to assign a drive ltter to the new drive in order for Ghost to recognise the destination drive. Pc Won't Boot From Hard Drive I have a tower (dell.

Reply Jay says: April 17, 2009 at 5:01 am Well here i am looking for answers to what i fear may be a dead drive. Still stuck? Reply sonu says: June 3, 2015 at 8:47 am i have a internal hard drive in which windows xp is installed,i want to fromat / clean it, so i can use Check This Out Installing a replacement drive is simply a matter of taking the existing drive out and putting the new drive in its place.

Your last option is hiring a data recovery service. Reply Robert Zeller says: May 17, 2009 at 3:05 am Oh, I should add that it crashed again… I haven't restarted it… could this be a power supply issue? Join the community here, it only takes a minute. That might be too much for the processors Reply Lee Tracey says: February 7, 2016 at 7:00 pm I have a different problem.

Jan 22, 2007 #5 SNGX1275 TS Forces Special Posts: 10,715 +397 You are going about this entirely wrong I think. WARNING SPINRITE 6 on a 10GB drive can take 8hrs on a Pentium 3 (havent needed it on a new system so i cant tell you if it would be faster All of the other steps do apply, though. Maybe I should send this to him so that he will start looking for an IT consultant.

Smith January 25, 2011 at 6:15 pm I haven't tried an IDE to SATA clone myself. Cloning a drive may take some time because of the bandwidth limitations of USB 2.0, but it will complete eventually. I don't know how much time it works correctly ? HP Customer Support Support Home Products Software and Drivers Forums Contact Support Search Select your Model Let HP find my products Identify now HP can identify most HP products and recommend

Any advice? Reply Maggie Clarke, Ph.D. They happen 1 to 3 times a day when I'm using the PC for many different things. Please check out our community forum for help with your question.

I know that in Disk Management I could re-partition but that is not possible as I cannot see the drive to do anything to it. Currently, I have pressed F12 at start up and am running diagnostics and have gotten an error: Error code: 0142 Msg: Error-code 2000-0142 Msg: Hard drive 1 - self test unsuccessful Reply Mike April 17, 2011 at 6:24 pm I have 2 old IDE drives on my PC. Privacy Policy © Copyright 2017 HP Development Company, L.P.