Home > Hard Drive > Switching From IDE --> SCSI Hard Drives On Home Desktop.good Idea?

Switching From IDE --> SCSI Hard Drives On Home Desktop.good Idea?

Contents

Reply Johnny says: December 6, 2008 at 5:19 pm Not sure what all the fuss was about in some of your earlier posts, but you made this post easy to understand. His credits include dozens of books, blogs, and magazines. Turn off the power to the host system before installation. Or you can also use it with the USB-to-SATA adapter as an on-going backup drive. this content

This is because, for an IDE drive, it matters. It worked for my HP 540. Because these component events are mutually exclusive, there is no overlapping probability - which means that the probability of data loss is the probability of drive A failure plus the probability Rosco Reply Christy says: November 19, 2010 at 14:41 I have a Dell Precision T7400. http://www.techspot.com/community/topics/switching-from-ide-scsi-hard-drives-on-home-desktop-good-idea.19849/

Ide Hard Drive Jumper Settings

Terms of Use Privacy Policy Licensing Advertise International Editions: US / UK India CNET Reviews Best Products Appliances Audio Cameras Cars Networking Desktops Drones Headphones Laptops Phones Printers Software Smart Home If not, you can extend it using a controller card just the same way as with IDE. Posted on 2016-11-17 01:54:51 SXXX if drive has 1.000.000 or 1.500.000 hours untilll failure convertit to earth years will be around 100-170 years. Reply Rosco says: September 23, 2010 at 09:30 Hi Johnorean…sorry for the late reply… Do you still have this issue?

  1. Suggesting that implementing RAID is a bad idea because the built-in RAID controllers are of low quality is akin to saying that doing 3-D graphics is a bad idea because the
  2. Log in × Reset Password Email Reset Password Back to login × Lifehacker International Lifehacker US Lifehacker Japan Close Contact Us Blog Shop Drive Tracker Partners Work Order Request Help Request
  3. Reply Dyan says: December 22, 2007 at 11:20 am Joshcore, I purchased an external HDD caddy, and am trying to install and format an IDE 2.5″ hard drive (160GB, max partition
  4. Very helpful!!
  5. Vivek February 5, 2013 6:14 am Reply # David, Good posts in this site and it gives lot of ideas for affected people like me.
  6. When I weigh that against the benefits of RAID, I just can't recommend it except in very select cases.
  7. Follow this Windows 10 Redstone 2 14894 … How to Update Windows 10 to Threshold 2 with Backups?. 2015-12-01 14:57:14 Tracy King - Here in this passage you’ll find detail steps
  8. I am not able to install Windows XP OS CD.
  9. At his stage you would hopefully be able to browse the drive and retrieve your files.
  10. Cancel Edit × Comment Voting Up Votes Down Votes × Only logged in users may vote for comments!

Posted on 2015-11-22 18:18:00 Guest_47 "Take any introductory statistics course and you'll learn that...", said the anti-social guy who thinks he knows something about statistics. Finished! Most of the best solutions come from Google because they're both simple and free. How To Connect Two Hard Disk In One Pc The metal the case is built from is thicker than average so the screws I have do not reach to try and install it that way.

Toshiba Satellite L45-S7409 Please advise Thank you Reply Dave says: May 28, 2011 at 18:55 nevermind I did Solution 2 successfully thanks for the great info Reply moe says: June 5, How To Connect Ide Hard Drive To Sata Motherboard You save my time a lot. sometimes learning new stuff is also learning how to say it. look at this web-site If you are replacing your primary hard drive, make sure you back up any data you want to save before you start.

high failure rate etc Reply 0 bigdirtyjase @bigdirtyjase Feb 10, 2014, 1:27pm OCZ drives did have a high failure rate due to crappy firmware and some of their drive lines were How To Connect Hard Drive To Motherboard Do you still need to have a jumper on the hard drive or does the microboard in the adapter handle that like the new SATA drives do? If not, reset the Bioks to factory defaults, restart and check again. Some popular manuafacturers are listed below: HP/Compaq Support IBM/Lenovo Support Dell Support Extract the downloaded driver to a blank floppy disk DO NOT insert the floppy disk into the computer that

How To Connect Ide Hard Drive To Sata Motherboard

Boot using Ubuntu live CD. Anonymous April 26, 2013 9:54 am Reply # Great help thank you Avtar Singh May 1, 2013 9:33 am Reply # Hello Sir , I have hard drive .At night i Ide Hard Drive Jumper Settings tnx Reply uttam says: December 19, 2012 at 22:40 sir, thank you so much for your advice. Sata Hard Drive Jumper Settings Thanks for getting me back on the right track.

I love the internet! http://hcsprogramming.com/hard-drive/usb-hard-drives.php and ur write he DIDNT start off with TAKE drive out of box… jeeees…. Materials Required Hard drive Copy of the hard drive manual (if you need to set jumpers; this can be downloaded if your drive didn't come with one) Controller card (optional; use Reply Robin says: January 18, 2009 at 9:00 am Nice guide, but you tell vista doesnt show the HD till you format it. To Install A Second Ide Drive Into A Computer You Must

Thanks! In the days of cloud storage and streaming media, SSDs provide plenty of space for most people. But not parity. have a peek at these guys At the command prompt window, type in diskmgmt then press Enter.

My hard drive crashed, but I had a back up one. Sata Cable Reply Tom says: January 24, 2009 at 4:40 am Hi I am trying to install a new sata drive onto my pc. P.S.

Thanks for all your help.

The intent was just a secondary drive for extra space. How To Choose The Right SSD The process of choosing an SSD can seem a little overwhelming with so many brands available. Reply Paul says: February 22, 2008 at 11:50 pm i have a SATA hard drive and their is a driver issue and ITS PISSIN ME OFF (sorry had to say that) Ssd Thanks, hope to hear from you or another one of the commenters soon.

Well it sounded so simple but no matter what I do I cannot get the computer to recognize my old drive connected to the slave connecter on the cable. Also I dont have a floppy drive so cant download from there. Reply Anonymous says: January 24, 2011 at 07:29 Top Class, worked for me. check my blog From reading your article, it sounds like I will have to format all data off the drive if I want it to be recognised by Windows?