Why Won't You Work Sata?
discharge your body’s static electricity before you open the computer case. Ask a question and give support. Is there more than one SATA port you can try? Each planet, and the vast stretches of space between, hold frightening dangers and wonderful opportunities. get redirected here
this however add the option that the disk was damaged and died a bit later, doing damage whilest dying. Yes, my password is: Forgot your password? It sees my SSD's just fine, but acts like nothing else is plugged in. My best advice is read your documentation if you don't understand it have your dealer help you and then do what it says, and really be certain to use an adequate
Sata Power Connector
That's how it works.. Advertisement 2. Buying Guides SSDs Are About to Skyrocket in Cost: Should You Upgrade in 2017? The IDE HD had to be on the secondary IDE cable in order for it to be recognized by the sata drive.
- responsibility helpful!!
- It's a DiamondMax Plus10 250GB SATA drive.
- My SATA conked out, and I wanted to get up and running right away, w/o buying an expensive SATA at a brick&mortar store nor wait 5 days for a it to
i mean that the controller is still there and it could need a driver even if the feature is disables as on via k8m800 chipset ( ga-k8m800 ) as reference, even Depending upon your bios and startup options, if it is like mine you have the option either within the bios, or at startup, which drive to choose as the primary. When the controller answer the Installer query about its HDD and devices it had plugged, and the controller report about the HDD, it don't matter which interface it is now. Sata Data Cable The problem of reinstalling Windows on a SATA boot device still happens with XP, but almost the first message from Windows asks you to "press F6 to install a Raid controller".
Sep 8, 2006 Why Won't You Work Sata??? If you don't feel like replacing the motherboard and have some room left in your case, you could get a PCI SATA adapter, that way you can avoid using the potentially PlayStation Vue: How Do They Compare? Get the answer patJan 17, 2006, 5:01 AM Quote: Thanks for the reply,I'm using the native chipset controller in the motherboard - it is said to be raid complient anyway...I'll try
Marko LesicnikAug 28, 2013, 11:22 PM Thanks for your reply. Sata Interface Cable Thanks. install dont give a fuck about the interface, it just interrogate the controller with basic IDE command, and if the controller answer then any drive attatched to it will be reported WinXP on an IDE drive won't see a SATA drive.
Sata Hard Drive Power Cable
Still not showing up in "My Computer". stupid problem that's cost me 2 days of my life but nevermind... Sata Power Connector The image below shows what SATA (red, left) and IDE (grey, right) cables look like. Sata Power Cable Jul 10, 2009 Add New Comment You need to be a member to leave a comment.
The drives should be detected. Get More Info pfff! by R. I'm fire; I compress—what on earth am I? How To Connect Sata Hard Drive To Motherboard
But off course you won't get more performance if the drive itself doesn't allow anything above 3 Gb/s. Join thousands of tech enthusiasts and participate. Did you expect tougher challenges when you install a SATA hard drive? useful reference I installed Windows on the SATA drive.I built this computer myself and haven't had any problems with this configuration.
I later got it replaced as Seagate had a firmware problem that killed hard drives. Sata Connector To Usb Either damaged, or disabled in the BIOS. It's better to have SATA for primary, but the speed wouldn't be a big difference Flag Permalink This was helpful (0) Collapse - I have a problem with mine by Laurenksmith
All Rights Reserved.
by R. If you believe this post is offensive or violates the CNET Forums' Usage policies, you can report it below (this will not automatically remove the post). Reply Calvin December 31, 2015 at 6:48 am Not sure why my motherboard doesn't recognize the sata ports for these 2 hard drives I'm installing. Hard Drive Sata Cable Read more.
Proffitt Forum moderator / December 10, 2006 3:26 AM PST In reply to: SATA HDD + IDE drives w/ SATA adapters Burying a new discussion here is not going to find SO WHY CAN'T I USE MY HARDDRIVE? because DOS is 16 bits and Installer is 32 bits.. this page It could be that the drive has also failed...
PCI Express slots are currently for video cards.Bob Flag Permalink This was helpful (0) Collapse - Mixing SATA and IDE drives by Sheridan / July 22, 2005 1:02 AM PDT In So, does anyone have an idea as to what might be going on? A long line of mysterious planets, all stranger than any story, lie between the birthplace of the young crew and their destination among the stars. This way, you simply use your drive as any other drive..
Ask ! Events from twenty thousand years in the past have much to teach the new crew, but they fall into a deadly trap from which even the captain cannot find an escape. morgJan 18, 2006, 6:00 AM how to install windows XP on a raid controller for newb:be certain you have the dos raid driver disquette, ( could be made from mobo cd Neither the new or the old drive is detected by BIOS, my Vista install disk, or from my bootable Linux USB drive.
I have a Gigabyte motherboard that will take 4 SATA drives, 2 PATA drives and 2 CD/DVD drives so I can use the PATA drives in a RAID Array as the It used to work but after the mobo install the bios recognized an unknown drive instead of the other hd. Help Please. You'll see that you don't need drivers.
All Rights Reserved Tom's Hardware Guide ™ Ad choices Articles & News Forum Graphics & Displays CPU Components Motherboards Games Storage Overclocking Tutorials All categories Chart For IT Pros Get When I started it again it would not boot. I have two SATA drives as my main drives, and I have two IDE drives (one refuses to operate), so I installed the one IDE drive into my system, and have By the way, what are the short pci express slots for?