Home > Power Supply > PSU Used For Fans

PSU Used For Fans


The three pins are used for ground, +12V power, and a tachometer signal. Technologyreview.com. Hope that's not too dumb a question. Why wouldn't I just connect my entire system to the power wattage monitor station if I need to measure the total system wattage consumption. http://hcsprogramming.com/power-supply/when-turning-power-on-fans-start-but-then-fade-do-i-need-to-replace-psu.php

General system examples: A system with under 1ghz processing with 2 5,200 speed hard drives, 2-3 CD-ROM devices, floppy, 2/3rd of the peripheral slots used would typically be fine with a Since HIGH POWERŪ power supply's wattage rating is based on the maximum performance of this same total DC output power (and not maximum AC power that can go into our power Reminds me of a story... What do you mean, how to connect the transistor drivers? more info here

Power Supply Cooling

In this article, i will explain the basic and most common fan type. plz help email me at [email protected] or in fb accnt.. But i have not find anywhere a norm that declares if the fan MUST operate or not with the 4th wire unconnected. Answer: A lot of people asked about this.

If you believe this post is offensive or violates the CNET Forums' Usage policies, you can report it below (this will not automatically remove the post). This emulates a fan rotating at 1500 rpm.At 3 April 2012, 16:31:06 user Dan Canham wrote:[reply @ Dan Canham]Is it possible to fool a motherboard into thinking a 4 pin fan Retrieved 2015-02-20. ^ "EC 4510 fan series". Data Bus And Address Bus speed lower than the CPU fan), would they run at 1500 rpm and presumably get overloaded or would they just run at their max.

The wattage rating of a PC power supply is not officially certified and is self-claimed by each manufacturer. What are these extra connectors off the power supply for? The controller will then malfunction, because it needs constant current to operate. There are specially designed cases with vents that allow better air flow through the system in which the power supply fan can either blow out the air from the back or

Retrieved 2009-12-11. ^ Silent PC Review Recommended Power Supplies, retrieved 2010-08-01 ^ Greene, Kate (2009-05-19). "A Laptop Cooled with Ionic Wind | MIT Technology Review". Computer Power Supply Could've been out for months for all I knew. check out my circuit pages.At 1 May 2015, 10:13:07 user Giorgos Lazaridis wrote:[reply @ Giorgos Lazaridis]@Stephen get a 5V fan, stick it under the laptop power through usb. Image used with permission.

  1. Usually it is red and black or on some fans yellow and black.
  2. Obviously, the only way to know this is to open up the power supply and ... 2 Step 2: ToolsDepending on the type of computer and type of power supply, you
  3. basically I'm looking for any comparable fan to replace the existing Sunon KDE2406PTB3 DC24V 1.4W fan.At 25 October 2015, 6:57:55 user Giorgos Lazaridis wrote:[reply @ Giorgos Lazaridis]@Louis most likely yesAt 24
  4. It is now a required feature for all power supplies shipped to Europe.
  5. Static pressure is usually stated in either mm Hg or mm H2O.
  6. Is it possible to let the fanblades spin the other way?
  7. The power supply requires a minimum amount of voltage/current from the electrical outlet it is using.
  8. If the PWM Duty cycle is bellow a threshold value, then the fan either shuts down, or it remains in a stable 'LOW" rpm.
  9. Answer: The Fan Speed Monitor connector, when connected to an available fan port on the motherboard, provides real time rotational speed of the power supply fan to the system.

How Does Power Supply Keep Cool

An Anglo-American whose life goal is to be a narrator on 'Drunk History'. http://www.tomshardware.com/forum/244287-28-power Thanks to KanyonKris for the correction (see comment at bottom)Step 1: Before you start You will need to know what kind of fan you need to replace. Power Supply Cooling If the fans in the power supply stop working, then overheating can occur in the power supply as well as the rest of the components inside the computer. Heat Sink Function Typically, square 120mm and 140mm case and power supply fans are used where cooling requirements are demanding, as for computers used to play games, and for quieter operation at lower speeds.

Related Resources solved How to power a fan without a PSU? The illustration above was taken from Mouser, a large distributor of electronic parts. Digikey is the same.

I too was surprised I couldn't quickly find a good source adapter is 11-13.5v / 1.18-0.96A when I connect them, the fan starts running pretty quick, but inmediately after it slows down its speed, what makes me think that the fun is solved How to reset a acer aspire e-14 without using power button solved how to join two fans to one pin fan header without y-cable solved How long can GPU last Power Supply Definition

Michael Flynn wwww.FunExhibits.comAt 8 May 2014, 6:12:52 user Scoute wrote:[reply @ Scoute]@Giorgos Lazaridis, thanks for the reply. Retrieved 2015-02-20. ^ "EC 3510 fan series". If you are absolutely sure that no overcurrent will occur, then yes, you can directly connect the transistor without base resistor. If it rotates, then no problem!

The standard size of a square computer cooling fan is about 80mm; however, other sizes such as 60mm, 92mm, and 120mm can be chosen as required. Hard Disk Drive What is your recommendation? Thanks in advance!At 19 October 2010, 14:11:20 user Kammenos wrote:[reply @ Kammenos]Depends Jack.

More resources See also solved How do I configure my pc to boot without a cpu-fan plugged in?

Another way of detecting an overheating condition is through hardware that monitors the internal temperature of the system. The current is about 30mA.I will have to do some dismantling to see whether there is a control circuit outside the motor. ball" isn't the only dimension upon which to measure cooling fan quality, it is an important one. Ram Definition Is this normal?At 13 September 2013, 21:33:25 user Giorgos Lazaridis wrote:[reply @ Giorgos Lazaridis]@lindsay norris Sure you can.

Due to the fact the summer is approaching and the ambient temperature will get higher, I wanted to be sure that my CPU was being cooled off!! The "silencer" label identifies it as a fan specifically engineered to reduce the noise level of the system. Would that work? Opening your PC may void its warranty, though I haven't come across such a computer so far.

Flag Permalink This was helpful (0) Collapse - In answer to the question in your first post by lacsr / September 20, 2007 12:59 AM PDT In reply to: A couple Text is available under the Creative Commons Attribution-ShareAlike License; additional terms may apply. The fan will always run at full speed (as the control pin will not be used), but the rpm feedback (tacho) of the fan will operate normally and the motherboard will Please read the Site Guide before using this material.

Can I connect a 4-wire fan to a 3-wire connector? I plugged it in and it seems to work fine but I don't want to cause a fire or for this to overheat. Is it possible for a 2-pin outlet to power a 3-pin fan?At 30 December 2013, 23:45:33 user Giorgos Lazaridis wrote:[reply @ Giorgos Lazaridis]@jemas you will have to do major hack job So now my question is, would it be possible to use the blue wire to create some way to adjust the fan speed, like with a knob or something.

Question: Windows 98 Second Edition Shut Down Problem Answer: Some systems may have problem automatically shutting down the power supply due to issues with the motherboard. The width of square fans and the diameter of round ones are usually stated in millimeters. Then Strip the cable so you see 4 wires. With some proper software it should be possible.

A higher wattage power supply is recommended for systems using more drives or peripherals than a typical system load. so it is not possible... Anyway, thanks again. In that kind of situation, the temperature creates a lot of tension on the electronics components in the power supply or motherboard, having the computer on all the time helps maintaining

Thanks for write this instructive article .At 21 January 2016, 17:50:23 user Johan wrote:[reply @ Johan]Hi!