Home > Power Supply > Weird Problem Power Supply

Weird Problem Power Supply


Could my power supply have shorted out the mother board? Wrote it off as Vista being a POS. The PSU is about 8 years old (Antec NEOPOWER 480W ATX12V Active PFC Power Supply). Lots of reasons it could be actually. my review here

The symptom is very strange. I normally go up one size when replacing power supplies.Replacing a power supply is pretty straightforward. This will show whether the supply is operating correctly and if the supplied voltage is within the proper tolerance range. Common power-related symptoms include:Any power-on or system startup failures or lockupsSpontaneous rebooting or intermittent lockups during normal operationIntermittent parity check or other memory-type errorsHDD and fan simultaneously failing to spin (no http://www.tomshardware.com/answers/id-2747216/weird-power-supply-problem.html

Signs Of Power Supply Failure

Also please exercise your best judgment when posting in the forums--revealing personal information such as your e-mail address, telephone number, and address is not recommended. Reply Ryan says: July 7, 2014 at 1:04 pm My pc is suffering most of the listed symptoms above. Reply hassan says: February 21, 2015 at 4:02 pm hp pavilion a705w tower computer i use but his power suply ac input 100_127v……4.0A atx power suply not on i replace and

  • Somthingsick909Aug 2, 2015, 8:18 PM I checked all the cables like the cables that plug into the mother board and everything is plugged in just fine i unplugged and re-plugged them
  • The power supply i purchased was a Corsair CX 600watts and is the same brand as the old powersupply that had stopped working on me.
  • Stay logged in Search titles only Posted by Member: Separate names with a comma.
  • I used to do this sort of thing building circuits for 8 bit microprocessors back in the early 80s ...
  • Did you go to MSI and see if its listed as one they tested with...
  • Check the power lead to the CPU fan. (This is usually a small-gauge pair of wires that can break if you pull too hard.) On some PCs, you must also remove
  • This article outlines how to diagnose a faulty supply by testing its voltage outputs, as well as how to replace the defective unit.The symptomsJust about any intermittent problem can be caused
  • Thanks.My 3.3 volt rail is low (2.8v).

Remove that little cover and you will expose the shaft that the fan spins on. Latest: ponyo, Jan 20, 2017 at 10:59 AM Off Topic What would you like to see during President Trump's first 100 days? The shaft fits very snug inside a "tube" or sleeve. Power Supply Failure Causes A notch or 2 on the cpu won't hurt a thing either. #2 Mucker, Oct 27, 2007 Yzzim Lifer Joined: Feb 13, 2000 Messages: 11,990 Likes Received: 0 Alright, I'll

That was the only symptom. Power Supply Failure Symptoms Newer Than: Search this thread only Search this forum only Display results as threads More... Just one quick followup. http://www.techrepublic.com/article/learn-to-troubleshoot-power-supply-problems/ I researched it and found many other people (including lots of people who bought the TigerDirect barebones kit like mine) having the same problem and they were able to get it

solved Acer N1996 Power Supply connector problem solved What kind of power supply would I need to run a gtx 1080? Computer Power Supply Problems And Solutions Pdf Reply Ramblinrick says: April 17, 2012 at 10:56 am Cheryl, Were you experiencing this problem prior to replacing the power supply? First, let's look at these fans and how they work, and what makes them fail. Reply Ramblinrick says: October 8, 2010 at 7:08 pm TechPaul, Thanks for the support.

Power Supply Failure Symptoms

Doesn't rot rubber as it's not petroleum based.

if you do dismantle, just drop a tiny bit in off the end of a teaspoon. I bought a cheap one real quick to make sure that was the problem and it was and the cheap one i bought was 550watt compared to the old one at Signs Of Power Supply Failure Second symptom was more recent. Power Supply Problems And Solutions You are right, it is "my noise" 🙂 I agree, power supply or motherboard… When it starts smoking, time to replace.

I've tried removing everything and reseating everything. this page So now i dont know what to do? Austria (@rbnstr08) says: August 14, 2012 at 6:51 am 4gig DDR2 and AMD 2.2ghz? Hey, I should start an PC section on MY blog, LOL. How To Check If A Power Supply Is Working

I managed a network of PCs and not once did I experience a PSU issue. SO, don't buy an OEM processor, buy retail to get the cooling unit when ordering. Thanks all solved Can I use two 4 pin power supply connectors in ATX 12v 2x4 motherboard? get redirected here Spinning the fan until it spins freely.

I bet you have experienced this! Power Supply Troubleshooting And Repair Advertisement A Desktop Computer PSU Might Look Like This Can Anything Be Done to Prolong the Life of a PSU?Yes, there are a few things that will help you get the One additional suggestion I would also make is to any tech.

More »More by SuperTech-IT:Add instructable to: Contest GroupRelatedNoisy Computer Fan Repairby pfred2Cheap Laptop Cooling!by CalcProgrammer1How to make a ECO desktop fan from old computer partsby tksjaFEATURED CHANNELSWoodworkingPaperKitchen HacksPuzzlesLaser CuttingSpaceHomesteading3D PrintingSewingNewsletterJoin 2

No, create an account now. Now those same PSUs cost $20 with the same warranties ranging from 6 months to 2 years.Most then and now are made in China and meet US certifications.So how do I If you are unsure or uncomfortable with working around high voltage,don’t! How To Tell If Your Psu Is Dying Reply Marcos says: June 11, 2015 at 8:00 pm Hello, I've been having a problem which I believe might be the PSU.

Later that night same thing only this time it would not boot, it got to the single MB beep to say all is well but no further. I was playing with the various fan settings and some of the anti-interference settings (Spread Spectrum, HTT, etc). Luckily, this is a server PSU, and it has been made to be rock-solid even if one of the two fans fail, so it works well. http://hcsprogramming.com/power-supply/which-power-supply-should-i-buy.php Slide the new supply into the case and connect all the power leads, starting at the motherboard.

Antec 1200 high current pro. I think it was a driver issue. 3rd, I've seen a boot slow down with a bad cd-dvd rom that had media in the drive. The price normally reflects the number of special features built into the meter. I was able to reformat thinking it was the booting problem.

Reply Don Wolf says: April 15, 2016 at 5:45 am Thank you, n I appreciate all your input!! Buy Now True StoryI was at a client's house to have a look at her computer. Really weird… Rick Ol-Dad says: March 12, 2014 at 9:14 pm Rick - Thanks for your patience - the answer to your question is no - there are three ways to Only 2.2GB registered on DxDiag. | Gateway FX541S 8GB of RAM?

Disruptive posting: Flaming or offending other usersIllegal activities: Promote cracked software, or other illegal contentOffensive: Sexually explicit or offensive languageSpam: Advertisements or commercial links Submit report Cancel report Track this discussion Lol. Reply Billy says: August 26, 2013 at 8:08 am also a brother told me he tried to turn on my computer about 30 mins prior to the upgrade and it wouldnt Trollinjaflex9 months ago What if my PC was making electric shocks ,does this mean my psu is failing Firehawk4nzzz14 months ago ryansccs...thank you, i am truly grateful, i was under the

Only the devices that produce a natural electromagnetic current (fans) and the DVD drive (which was higher than the power supply) survived. The case fans spin up for a second and then stop. Occasionally cleaning the system out will also prolong its life. Dirt/Foreign Substance (cigarette smoke, house dust, etc.).

Can someone please help with this as its proving to be a real pain, thanks very much any advice would be much appreciated. 8 answers Last reply Jan 17, 2015 Best Anyway, I'm running my old setup with a new PSU and it's working great. When using the type of supply pictured, you don't even need to remove the side panels - absolutely no screwdrivers needed at all.